76
[ST] Set tare
Enter to set tare, the function operates like pressing of the
key placed on the indicator.
[CM] Mass condition
Condition-based function. Enter to determine mass-related
conditions for performance of the successive steps, e.g.: the
next step is to be performed when the net mass value of the
product on the platform is lower than the threshold value.
Threshold Value of threshold mass for the condition.
Mass condition Threshold condition – „>=” or „<”.
[CI] Input condition
Condition-based function. Enter to determine conditions
with regard to the indicator input state for performance of
the successive steps. Input states: none – input inactive; „0”
– LO state (input off); „1” – HI state (input on); „/” – rising
edge on the input (state change from LO to HI, e.g.: the
moment of button pressing); „\” – trailing edge on the input
(state change from HI to LO, e.g.: the moment of button
release).
[EM] Set mass
Enter to enforce the operator to give manually mass of an
ingredient supplied in packaging of known weight value.
The entered mass is added to the weighed mass of the
ingredient.
• It is possible to modify created process steps using keys that correspond
with pictograms of the bottom display bar:
Symbol Description
Delete all process steps.
Delete one (marked) process step.
Add new process step at the list end.
Add new process step prior the marked list entry.
29.4. Dosing Procedure
• Select dosing process, do it by pressing a key to which pictogram
is assigned.
• Save general parameters of 'Dosing' mode to a scale memory,
the parameters are to be found upon pressing a key to which
pictogram is assigned.
• Press the key to which
pictogram (process start) is assigned, now scale
keypad is locked except for
- stop, - pause, - breakdown keys.
• The process starts, it is signalled by a blinking
symbol
displayed in the top bar of the screen.
To Next Page
Loading...
