65
Procedure:
• Enter <Working modes> menu and select respective working mode.
• Enter <Result control> submenu and set respective option.
Where:
Each weighing is recorded.
Weighings between MIN, MAX thresholds are recorded.
For detailed description on how to set MIN, MAX thresholds
refer to section 13.6.
For MIN=0 and MAX=0 the
, , pictograms are inactive.
25.6. Autotare
Autotare function allows you to quickly determine the net weight for loads with
different tare values, which loads are measured one after another. When
<Autotare> function is on, the operation cycle takes the following steps:
• Make sure that the weighing pan is empty and press zeroing key.
• Load the weighing pan with product packaging (packaging weight value
must be greater than the set value of <Auto threshold> parameter).
• Upon indication stabilization, packaging mass is automatically tared
(
pictogram is displayed in the upper part of the display).
• Put/pour/dispense product that is to be packed into the packaging. Net
weight value of the product is displayed.
• Unload the weighing pan (remove both product and packaging).
• When the weighing device detects weight value lower than <Auto
threshold> value, the entered tare value gets automatically deleted (
pictogram is no longer displayed).
• When you load the weighing pan with a new product packaging,
analogous set of operations proceeds.
25.7. Labelling Mode
Labelling system is designed to print labels for product marking. The program
generates standard labels, for single products, and cumulative labels, for bulk
boxes.
To Next Page
Loading...
