30
• If you are waiting too long for the communication to be established
it means that incorrect parameters must have been entered (e.g.
password). Check the settings and try to establish communication again.
• If you fail to establish the communication, contact RADWAG service team.
The selected network and settings of parameters for connection are stored in
a scale memory. The scale connects to the network in accordance with these
settings each time it is switched on. To disconnect the network go to
<Activation> parameter.
14.4. USB A
USB port of type A is intended for:
• connecting a USB flash drive in order to enable:
- printout of measurement data (set <Printer/Port> parameter
to <Pendrive> value),
- database export/import,
- operator parameters export/import,
- Alibi and weighing reports export,
• connecting a scale to a PCL printer,
• connecting EPSON TM-T20 printer (featuring USB port).
The USB flash drive must support FAT files system.
14.5. USB B Port
USB port of type B is intended for connecting the scale to a computer. In order
to make connection of scale and computer possible, it is necessary to install
virtual COM port in a computer. To carry out this procedure, you need a
respective driver installer which may be either downloaded from
www.radwag.pl
website or taken from a CD with manuals: RADWAG USB
DRIVER x.x.x.exe.
Procedure:
1. Run the driver installer and follow the commands.
Select language version and press
„OK” button to confirm.
To Next Page
Loading...
Need help?
General
