29
No. Pictogram Description
1
The weighing device is connected, very strong signal.
2
The weighing device is connected, strong signal.
3
The weighing device is connected, poor signal.
4
The weighing device is connected, very poor signal.
5
No connection (signal too poor, selected network unavailable,
connection parameters invalid – password, IP etc.).
Set the transmission parameters in accordance with your local
network.
In order to provide correct communication between the
computer and the weighing device via <Wireless
communication> port, you must set computer port parameter
in your scale to <Wireless communication> value. You must
also set wireless communication parameters, to do it correctly
follow the below procedure.
Procedure:
• Enter <Activation> parameter and activate wireless communication.
• Enter <Network configuration> submenu and set respective values:
Network scanning
Enter this parameter to trigger automatic search for available
networks.
DHCP
- select this option to make the program automatically read and
display data assigned by a Router to which the weighing device is to
be connected.
- select this option to enter manually data such as: <IP
Address>; <Subnet mask>; <Default gateway>.
IP Address
Enter this parameter to set weighing device IP address.
Subnet mask
Enter this parameter to set subnet mask.
Default gateway
Enter this parameter to set default gateway.
• When you run <Network scanning> function, the scanning starts and
message "Network scanning. Please wait…” is displayed, next you see
a list of networks detected by the weighing device along with signal
strength and network channel number.
• Select the network you want and enter the access password (if required).
• <Wireless communication> submenu is displayed, connection procedure
runs automatically.
• When the communication gets established, <Connected> status is
displayed.
To Next Page
Loading...
