RADWAG PUE C32

63
Remaining specific functions referring directly to a given working mode are
described further down this user manual.
An on-screen button
(working mode parameters) that is to
be found in each working mode home screen, provides direct
access to settings of the given working mode.
25.1. Readout
Readout submenu comprises functions allowing you to adjust your weighing
device to ambient conditions of a given workstation.
Filter
Enter this parameter to adjust your weighing device to ambient conditions.
The higher filter level, the longer the indication takes to stabilise. Options:
Very fast, Fast, Average, Slow, Very slow.
Value release
Enter this parameter to adjust the rate of stabilisation of the measurement
result. Depending on the selected option, the weighing time is either shorter
or longer. Options: Fast, Fast plus reliable, Reliable.
Autozero
Enter this parameter to enable automatic control and correction of zero
indication. There are, however, some cases when this function can be a
disturbing factor for the measuring process. e.g. very slow placing of a load
on the weighing pan (load adding, e.g. pouring, filling). In such case, it is
recommended to disable the function. Options:
- function disabled, -
function enabled.
Last digit
Enter this parameter to enable/disable display of the last digit (placed on the
right of the decimal point) of the weighing result. Options: Always: all digits
are displayed. Never: last digit disabled. When stable: last digit displayed
only when the result is stable.
Ambient
conditions
Parameter relating to ambient and environmental conditions of the
workstation. Enter this parameter and set 'unstable' value if the ambient
conditions are unfavourable (air drafts, vibrations). Values: Stable, Unstable.
25.2. Proximity Sensors
The weighing device is equipped with two proximity sensors which enable
touch free control. The program detects two motions performed around the
sensors:
1. Hand in a close vicinity to the left sensor <Left sensor>.
2. Hand in a close vicinity to the right sensor <Right sensor>.
Each motion can trigger optional weighing device function. For available
functions list read section 18.2. Upon completed configuration procedure, the
software runs function assigned to a particular proximity sensor, having
detected motion around it. To provide correct operation, it is necessary to set
respective proximity sensors sensitivity (read section 21.4).