Radwin 2000 D+ - Page 59

RADWIN2000D+UserManual Release3.6.00 6‐7
ActivatingtheRT‐A(HBS) Chapter6
ThisreleaseintroducesautomaticDynamicBandwidthSelection:Ifyouchoose
80MHz,thelinkmaydynamicallyswitchbetween80,40MHzor20MHzCBWto
ensurethebestthroughput.Ifyouchoose40MHz,itmaydynamicallyswitch
between40MHzor20MHz.Selectingofoneof20,10or5 MHzCBWsetsyour
choiceasthefixedCBWforthelink.Wewilluse80MHz.
9.UsingACS:
• Choosing40or80MHzCBWautomaticallyenablesACS.Allthatyouma ydois
removesomeofthechannels:
Note
Ifyourhardwaresupports250Mbpsnetaggregatecapacity,youshould
choseatleast40MHzChannelBandwidthtoenableit.