Radwin 2000 D+ - Page 88

RADWIN2000D+UserManual Release3.6.00 7‐8
Management Chapter7
3.ForSecuritymodelyoumaychoosebetweenSNMPv1orSNMPv3.Thechoiceissite
dependent.IfyouchooseSNMPv1,youmayonlyenteranIPaddressandport
number.ForSNMPv3,youshouldsupplyausernameandpassword:
4.ClickOKtosaveyourchoice.
Notethatforeachactivetrapdestination,theClearTrapDestinationbuttonisenabled:
VLANforManagement
ManagementVLANConfiguration
Figure7‐4:VLANforManagement
VLANManagementenablesseparationofusertrafficfrommanagementtrafficwhenever
suchseparationisrequired.Itisrecommendedthateachmemberofasectorbeconfigured
withdifferentVLANIDsformanagementtraffic.(Thisreducesyourchancesofaccidentally
lockingyourselfoutofthelink.)
 ToenableVLANformanagement:
1.InthewindowofFigure 7‐4,checktheEnabled box.
2.EnteraVLANID.Itsvalueshouldbebetween2and4094.
AfterenteringtheVLANID,onlypacketswiththespecifiedVLANIDareprocessed
formanagementpurposesbytheRT‐A(HBS)/RT‐B(HSU)ODU.
Thisincludesallthe
protocolssupportedbytheODU(ICMP,SNMP,TelnetandNTP).UsingVLANforman‐
Caution
VLANIDsareusedbyRADWINproductsinthreeseparatecontexts:
ManagementVLAN,TrafficVLANandEthernetRing .Itisrecommendedthat
youusedifferentVLANIDsforeachcontext.