Radwin 2000 D+ - Page 90

RADWIN2000D+UserManual Release3.6.00 7‐10
Management Chapter7
Foralinkmanagedaspartofanetwork,directaccesstoeithersiteusingTelnetisconsidered
tobeasecuritybreach.TelnetaccessmaybeenabledordisabledbyclickingtheProtocoltab
andenabling/disablingTelnetaccessusingtheTelnetcheck‐box.Similarconsiderationsapply
toaccessviatheWebInterface.
• ForfurtherdetailsaboutTelnetaccessseeConfigurationwithTelnet.
• ForfurtherdetailsabouttheWebInterface,seeUsingtheWebInterface.
TelnetandWebInterfaceaccessmodeswhenavailable,aresitespecific.Ifforexample,you
wantTelnetaccessfromaspecificsite,youshouldenableitforthatsitesanddisableitforthe
other.
Conversely,Ifthe TelnetorWebInterfaceaccessmodesposeageneralsecurityrisk,youmust
disablethemforeachsiteseparately.
MultiuserSupportunderSNMPv3
IfyouchoseSNMPv3orbothversions,youareaskedtologonagain:
Forthefirstlog‐onunderSNMPv3,useaspassword,theUserName,admin.Thereisone
changetothemainwindow.ThetitlebarnowshowstheSNMPv3username:
Further,thereisanadditionalbutton,SNMPv3Users,intheManagementwindow: