A-D Converter
M30240 Group
Rev.1.00 Sep 24, 2003 Page 106 of 360
1.2.24.4 Repeat-sweep mode 0
In repeat-sweep mode 0, the pins selected using the A-D sweep pin select bit are used for repeat
sweep A-D conversion. Table 1.34 shows the specifications of repeat-sweep mode 0. Figure 1.102
shows the A-D control register in repeat-sweep mode 0.
Figure 1.102: A-D conversion register in repeat-sweep mode 0
Table 1.34: Repeat-sweep mode 0 specifications
Item Specification
Function
The pins selected by the A-D sweep pin select bit are used for repeat sweep A-D
conversion
Start condition Writing “1” to A-D conversion start flag
Stop condition Writing “0” to A-D conversion start flag
Interrupt request generation timing None generated
Input pin
AN
0
and AN
1
(2 pins), AN
0
to AN
3
(4 pins), AN
0
to AN
5
(6 pins), or AN
0
to AN
7
(8
pins)
Reading of result of A-D converter Read A-D register corresponding to selected pin (at any time)
A-D control register 0
(Note)
Symbol
Address
When reset
ADCON0
03D6
16
00000XXX
2
b7 b6 b5 b4 b3 b2 b1 b0
Analog input pin
select bit
CH0
Bit symbol Bit name Function
CH1
CH2
A-D operation mode
select bit 0
1 1 : Repeat sweep mode 0
MD0
MD1
Trigger select bit 0 : Software trigger
1 : AD
TRG trigger
TRG
ADST
A-D conversion start flag 0 : A-D conversion disabled
1 : A-D conversion started
Frequency select bit 0 0 : fAD/4 is selected
1 : f
AD/2 is selected
CKS0
WR
A-D control register 1 (Note)
Symbol
Address
When reset
ADCON1
03D7
16
00
16
Bit name FunctionBit symbol
b7 b6 b5 b4 b3 b2 b1 b0
A-D sweep pin select bit
SCAN0
SCAN1
MD2
BITS
8/10-bit mode select bit
0 : 8-bit mode
1 : 10-bit mode
VCUT
Vref connect bit
0 : Any mode other than repeat sweep mode 1A-D operation mode
select bit 1
1 : Vref connected
WR
1
1
Invalid in repeat sweep mode 0
0
Note: If the A-D control register is rewritten during A-D conversion, the conversion result
is indeterminate.
b4 b3
When single sweep and repeat sweep mode 0
are selected
0 0 : AN
0, AN1 (2 pins)
0 1 : AN
0 to AN3 (4 pins)
1 0 : AN
0 to AN5 (6 pins)
1 1 : AN
0 to AN7 (8 pins)
b1 b0
1
Note: If the A-D control register is rewritten during A-D conversion, the conversion result
is indeterminate.
Frequency select bit 1
0 : f
AD/2 or fAD/4 is selected
1 : f
AD is selected
CKS1
Reserved bit
Always set to "0"
0
0
To Next Page
Loading...
Need help?
General
