Firmware Updating
SM 5-5 M018/M019
System
Maintenance
Reference
7. For a USB connection, click [F/W Update (USB)] [A]. For a network connection, enter
the machine’s IP address in [MFP IP] [B], and then click [F/W Update (NET)] [C].
8. Check the control panel display for messages and the update’s current percentage of
completion.
The Update may take a while to complete. Do not turn off the power during the
update.
Turn off the power only when the machine beeps and “Firmware Update Done
Please Reboot” appears on the control panel display.
9. Wait until the machine beeps once and “Firmware Update Done Please Reboot”
appears on the control panel display.
Click [Close] to the update tool.
10. Turn off the power, and turn it back on.
After you turn the power back on, “Initializing” appears on the control panel display.
11. Wait until the initial screen appears on the control panel display.
If the initial screen does not appear after more than one minute, the update is not
complete. In this case, see “Updating Failure”.
12. Repeat Steps 3 to 5 to print the configuration page again.
Take note of the new firmware version (shown under “Firmware Version” on the
configuration page).
13. Reconnect the telephone line cable to the machine.
http://www.manuals4you.com
To Next Page
Loading...
