Service Call Conditions
M018/M019 3-6 SM Appendix
3.2 SERVICE CALL CONDITIONS
3.2.1 SUMMARY
This machine issues an SC (Service Call) code if an error occurs on the machine. The error
code can be seen on the operation panel.
Make sure that you understand the following points;
1. All SCs are logged.
2. At first, always turn the main switch off and on if an SC code is issued.
3. First, disconnect then reconnect the connectors before you replace the PCBs, if the
problem concerns electrical circuit boards.
4. First, check the mechanical load before you replace motors or sensors, if the problem
concerns a motor lock.
5. Fusing related SCs: To prevent damage to the machine, the main machine cannot be
operated until the fusing related SC has been reset by a service representative.
Enter the engine maintenance mode.
Press "O.K" in "Fuser SC Reset" with engine maintenance mode, and then turn the
main power switch off and on.
http://www.manuals4you.com
To Next Page
Loading...
Need help?
General
