Service Menu
M018/M019 4-14 SM Appendix
The "Reseller Default" menu can be entered directly at power-on. If you want to
enter this mode directly, try the following procedure SPC 232SF Reset Password.
1. Power OFF the unit.
2. Power ON the unit while holding down the “Copy” key.
3. Continue to hold down the “Copy” key until the display indicates “Factory Default
Execute”.
4. Release the “Copy” key.
5. Press the Down Arrow, the display will change to “Factory Default Execute”.
6. Press the OK key.
7. The machine will display “Executing” and will perform a soft boot.
8. When the unit returns to the ready condition, reboot by turing the Main Switch
OFF and then ON.
9. Set Language, Fax Number, Name and Country.
10. Reboot the machine.
4.1.3 FAX SERVICE TEST MENU
Entering the Fax Service Test Menu
Turn ON the machine while pressing the "Fax" key.
Selecting an Item
To select the item, press the "Up" or "Down" key.
Going into the Next Level/ Returning to the Previous Level
To go into the next level of an item, select an item then press the "OK" key.
To return to the previous level of an item, press the "Return" key.
Exiting the Maintenance Mode Menu
To exit the maintenance mode menu, press the "Clear/Stop" or "Return" key until the
"Ready" display appears.
⇒
Rev. 07/02/2009
http://www.manuals4you.com
To Next Page
Loading...
