Technical Bulletin PAGE: 1/6
Note: The contents of this RTB are the same as RD137030 for Model Ch-C1 Pro.
Service Manual Revision
Replace “Removing Old Developer” on Pg 613 with the following.
Removing Old Developer
General
Replacing the developer without completely removing old developer causes the machine
to operate in a condition in which the applied toner density value is lower than the actual
value. This happens because the toner density sensor (TD sensor) initialization process
(SP3-030-001~006), which is performed when replacing the developer, always sets back
the toner density readings to the prescribed standard value 7.0% regardless of the actual
toner density, e.g. actual toner density could be 8% after replacing with fresh developer
but the TD sensor is calibrated to read this as 7%.
Continuous machine operation in this condition and incomplete developer replacement will
eventually cause the actual toner density to become too high and result in toner scattering.
This bulletin announces the procedures on how to remove old developer to prevent toner
scattering, in two parts.
Following are the expected effects:
Easier developer removal as a result of improved developer fluidity
Toner density will come close to the standard 7% after developer replacement
even if the dev unit is not completely cleared and contains a slight amount of
old developer.
Subject: Manual Correction: Developer removal procedure
From: PP Tech Service Dept., 1st PP Tech Service Sect.
Mechanical
Paper path
Product Safety
Electrical
Transmit/receive
Other ( )
Service manual revision
Retrofit information
Tier 2
To Next Page
Loading...
