Technical Bulletin PAGE: 1/5
Reissue: 26-Feb-15
RTB Reissue
The items in bold italics were changed.
SYMPTOM
There may be burrs along the edge of the tandem tray side fence. In rare cases, the
operator may injure their finger when loading the paper.
CAUSE
An indication to remove these burrs was not included in the diagram.
SOLUTION
Production line:
Temporary solution (Dec. 2014~Feb. 2015)
The edge protective sheet has been attached to prevent burrs on the production line.
For Office model
Subject: Procedure for attaching the protection sheet on
tandem tray
From: 1st Tech Service Sect., MFP/P Tech Service Dept.
Electrical
Transmit/receive
Service manual revision
Retrofit information