Rievtech x-Messenger Series - Highlight Feature

13
1.2 Highlight feature
Support Quad-band 850/900/1800/1900 MHz frequency
 Change the bit flag status and register value in the program via SMS
 Max. 64 different short messages and voice alarms
 Max. 70 Unicode Characters in one short message
 Time-based and event-based SMS, Call-IN, Call-Out, Ring.
 Email alarm
 IO status ,alarming message includes counters, analog values can be directly sent to Users
 GPRS optional (Wireless downloading/uploading configuration or monitoring)
 4 lines, 16-character per line, backlight display& keypad optional.
 Standard Modbus RTU/ASCII/TCP communication protocol supported
 It’s optional for x-Messenger to act as slave or master in certain Modbus communication
network.
 Access to internal resources with standard MODBBUS ACSII/RTU/TCP
 Expandable up to 8 linked IO expansion modules reaching 40DI/36DO,36AI/36DO in
maximum
 1 RS232(ELC-RS232 cable is required),1RS485 port(RS485 module is required)
 Optional Ethernet Interface
 Optional Wifi Interface
 Multiple channels analog inputs available with DC 0-10V signal, PT100 signal& 0/4….20mA.
 Default Real Time Clock (RTC)
 Backup at Real Time Clock (RTC) at 25 °C:20 days
 Two channels high-speed counting(60KHz)
 Retentive memory capability
 Power supply 12/24V DC, 110/240V AC
 RS232 communication download cable with photo-electricity isolation
 USB communication download cable with photo-electricity isolation
 Mounting via modular 35mm DIN rail or screw fixed mounting plate
 On-line monitor& Off-simulation by PC
 Pre-configured standard functions, e.g. on/ off-delays, pulse relay , counters ,watchdog function PI
controller etc..
 Logic functions-AND, OR, NOT, XOR……
 Standard configure soft& Customized soft(Function block diagram)
 Local and remote (Via GPRS/Ethernet) configuration ,programming and firmware update