2. The data transmission between x-Messenger and the server is based on standard Modbus TCP
protocol.
6.2.15 GPRS Data Upload
Short description
This block can be used to enable the GPRS connection and then transfer some information of the registers
to the network server.
Enable the GPRS connection according to the settings in
the property dialog box via trigger the input.
Reset the output and disable the GPRS connection even if
the Trg input keeps high.
Q is switched on after the GPRS connection is established
and the server software has made right response
according to MODBUS TCP . If the connection
disconnected, the output also shall be switched off.
To Next Page
Loading...
