Rievtech x-Messenger Series - How to Modify the Email Address of the Receiver Via SMS

45
##**
RPGPRS；
RPEMAIL；
Parameters
RPGPRS； This command is used to check the settings of GPRS. GPRS information would be sent to the user
who want to check.
RPEMAIL； This command is used to check the settings of GPRS. GPRS information would be sent to the user
who want to check.
3.3.1.6 How to modify the email address of the receiver via SMS?
Note: this chapter only for 2G version unit, not available for 4G version, you need change the phone book(Refer to
chapter 3.3.1.3 about how to change phone book).
Send an SMS message formatted like the example below
##**
EML,B002,1,B002,2,B003,1,B003,3:xLogic@163.com;
Message Parameters:
Start characters: ##** (These 4 characters must be included at the start of your message)
End character: ; (This symbol must be used to terminate each line of your message )
Parameters:
EML,B002,1,B002,2,B003,1,B003,3:xLogic@163.com; The receiver 1, receiver2 of B002
block and receiver1, receiver3 of B003 block would be modified to “xLogic@163.com”.
B002(Sms Message Output):