SMTPPORT"25",
SMTPUSER"xLogic@163.com",
SMTPPWD"12345678",
SENDNAME"chen",
SENDEMAIL"xLogic@163.com";
Message Parameters:
Start characters: ##** (These 4 characters must be included at the start of your message)
Parameters interval characters: , (This symbol must be used to differentiate each parameter of your
message )
End character: ; (This symbol must be used to terminate each line of your message )
Parameters:
PEMAIL : (This head means the below contents is used to modify the email parameters)
SMTPADR"smtp.163.com", This command is used to modify the SMTP for your Email box
SMTPPORT"25", This command is used to modify the SMTP for your Email box.
SMTPUSER"xLogic@163.com",This command is used to modify the user name for your Email box.
SMTPPWD"12345678",This command is used to modify the password for your Email box.
SENDNAME"chen",This command is used to modify the sender name for the Email.
SENDEMAIL"xLogic@163.com";This command is used to modify the email address for the sender..
You are allowed to send a SMS to check the settings as follows:
To Next Page
Loading...
