Rievtech x-Messenger Series - CALL-IN Function; I;O Status Remote Request

180
immediately. The default of that timing function is normally inactive and therefore must be activated.
WARNING
This device is not suitable for monitoring sensitive installations or time critical processes. GSM
network failure or power interruptions cannot guarantee a secure monitoring.
5.8.3 CALL-IN function
The CALL-IN function allows the user to activate the outputs by phone call for a certain time as described in
chapter 6.9.2. The device detects the incoming call and switches the outputs without answering. The outputs
are automatically switched-off after the preset time. This allows activating a process without costs.
REMARK
Activate the output timer to activate the field “Activate Call-In”!
5.8.4 I/O status remote request
With a successful established data connection (via GSM-network connection or via a serial cable connection,
Ethernet connection), the user can ask for the status of all inputs and outputs of the x-Messenger SMS Relay
including analogue input values.
REMARK
Modification of values and settings over remote access will not be immediately shown in the I/O
states display window. This takes some time and depends on the scanning cycle.