There are two option control modes for the SMS message input:
A.Incoming message B.Incoming Call
Incoming Message mode means that you can send a pre-set short message to control the state of “ SMS
message input“
Number identification: If the box were ticked, only the short messages from the telephone settings(Up to 5
user’s phone number can be selected from the phone book) can be recognized by the
x-Messenger, only when the contents is the same as the pre-set one,then the SMS
message input state would be changed correctly.
On instruction: Here you can pre-edit the short message contents to control the “SMS message
input“ ON/HIGH“. The default setting is1#1.
OFF instruction: Here you can pre-edit the short message contents to control the “SMS message input
“ OFF/LOW“.The default setting is “1#0“
OFF-Delay:If the “Enable Delay” box were ticked, after the message input status changes from Low to High
via a preset short message, then the status of SMS message input block would switch off(reset to
Low) on expiration of the preset delay time(1...99 seconds). If this item was not enabled, the SMS
message does not reset automatically.
Incoming Call mode means you can dial the phone number of the x-Messenger to control SMS message input
state. While the x-Messenger gets one incoming call but it does not answer, the SMS message state would
change from 0 to1. After the call being timed-out or cut off, the SMS message state would change 1 to 0.
Answer Call: If the box were ticked, the x-Messenger shall pick up your call but without any voice. This item
can help you ensure the x-Messenger has got your phone correctly and you can control the
SMS message input which keeps high for 10 seconds unless you cut off the call.
Note: If answer call is not selected. You call the x-Messenger would not have call cost. Contrarily, the call cost
would exist.
6.2.12 SMS message output
Up to 64 SMS message outputs are available. Each one of these message outputs can send an SMS message
or Call out without voice. Only the change from LOW-to-HIGH can trigger an SMS.
Caution ： Please remember every SMS message output needs at least one phone number in its list. The
display of special characters in the GSM network can cause problems. Please use only text characters and
figures. The programming software identifies special characters and an error messages will occur.
Short description
To Next Page
Loading...
