You can make the IP settings to factory by the menu
“RST IP Config”, the IP address will return to 192.168.0.201, and the tcp server port number will be 6400.
“RST Log on” the webserver log on name and password will be back to “admin”.
Modify the IP address:
Press ok to enter into the modification mode, the cursor will flash at the address position. The you can move
the cursor by Left or Right button, and change the value by pressing UP/DOWN button.
At last confirm with ok.
After you confirm the parameters with the ok button, the settings are not enabled , only after the CPU restart,
the settings will be enabled? So when you leave the settings the LCD will show you:
To Next Page
Loading...
