Rohde & Schwarz Scope Rider RTH1004 - Page 454

Remote Control Commands
R&S
®
Scope Rider RTH
454User Manual 1326.1578.02 ─ 12
ISO
Signals are decoded according to the ISO CAN FD protocol.
This protocol has an additional stuff count field before the CRC
sequence.
NISO
Non-ISO. Signals are decoded according to the Bosch CAN FD
protocol.
*RST: ISO
15.11.5.2 CAN Trigger
TRIGger:CAN:ACKerror..................................................................................................454
TRIGger:CAN:BITSterror................................................................................................ 454
TRIGger:CAN:CRCerror................................................................................................. 455
TRIGger:CAN:DATA....................................................................................................... 455
TRIGger:CAN:DCONdition..............................................................................................455
TRIGger:CAN:FORMerror...............................................................................................455
TRIGger:CAN:FTYPe..................................................................................................... 455
TRIGger:CAN:ICONdition............................................................................................... 456
TRIGger:CAN:IDENtifier................................................................................................. 456
TRIGger:CAN:ITYPe...................................................................................................... 456
TRIGger:CAN:TYPE.......................................................................................................457
TRIGger:CAN:FDATa:BRS.............................................................................................. 457
TRIGger:CAN:FDATa:DPOSition......................................................................................458
TRIGger:CAN:FDATa:ESI............................................................................................... 458
TRIGger:CAN:FDATa:FDF.............................................................................................. 458
TRIGger:CAN:FDATa:SCERror........................................................................................458
TRIGger:CAN:ACKerror <AckError>
An acknowledgement error occurs when the transmitter does not receive an acknowl-
edgment - a dominant bit during the Ack slot.
Parameters:
<AckError> ON | OFF
*RST: ON
TRIGger:CAN:BITSterror <StuffBitError>
A stuff error occurs when the 6th consecutive equal bit level in the mentioned fields is
detected.
Parameters:
<StuffBitError> ON | OFF
*RST: ON
Protocol Analysis