46 / 293 - EN -
1. Introduction
1.1. Preface
You have chosen an ST 310 controller, a high-quality product for your kiln. The control system incorporates the
latest technological features, is being continuously developed and is the leader in its class.
After reading this instruction manual, you will be familiar with the functionality of the ST 310 controller.
Please make sure that you fully understand the kiln manufacturer’s safety information. Make sure that the control
unit is mounted at a safe distance from the kiln and is not exposed to direct heat from it. Do not place the control
unit on top of the kiln.
The images in this instruction manual illustrate the functions and may differ in some ways from the actual product.
1.2. Scope of delivery
No. Part Remark
ST 310 control system The type varies depending on the version
Control unit bracket For attachment to the kiln or wall
Mounting material for bracket For attachment to the kiln or wall
USB flash drive Data transfer of recorded measured values
Instruction Manual
2. Control unit description
2.1. Product features
• Ideal for the ceramics use
• Single-zone control
• 32 Programs
• 2 controlled heating ramps, 1 controlled soak period and 1 controlled cooling ramp
• Soak times up to 99 hours 59 minutes
• Ramp rates between 1 °C/h and 999 °C/h or FULL
• Programs can be altered while the kiln is in operation
• Keylock
• Program start delay facility – up to 99 hours 59 mins
• Program pause facility
• Program advance function
• Continuation of kiln operation after a power failure
• Displays energy used
• Alarm function with buzzer
• Temperature display either in °C or °F
• Integrated Wi-Fi module for connecting to a wireless network and using the ROHDE myKiln app (see
Sections 8.1 & 8.2)
• USB port for data logging (see Sections 8.3 & 8.4)
• SolarReady: Optional “hysteresis” control for photovoltaic/PV systems (see Section 6.3)
To Next Page
Loading...
