Rohde ST 310 - Page 57

55 / 293 - EN -
Step Display Description Remark
4
Press and hold the h key for about 3
seconds after switching on until the date
appears. The date is shown on the main
display starting with the year.
The date is displayed in “YY.MM.DD”
format (year.month.day), with only
“YY.MM” appearing together on the
main display. By advancing with the g
key, “DD” appears alone on the main
display.
5
After the call-up, the numerical value for
the year flashes first.
6
22.01
Use the h or g key to select the
flashing number.
7
23.02
Use the d and f keys to change the
flashing number.
8
23.02
Change from year to month and from
month to day using the g key.
9
01
The last numerical value for the day of the
current date appears alone on the main
display after switching on.
10
01
You can now either use the g key to
advance to the time setting or wait about
15 seconds. The control system display
will then go dark for 2–3 seconds, and
the control system will restart
automatically. After the restart, the control
system is ready for normal operation
again.
The date is automatically saved with the
last setting after the restart.
Set time
11
07.45
Press the g key in the flashing day
display to go to the time.
For technical reasons, there is a point
between the hours and minutes in the
display and not a colon, as is usually the
case with times.
12
After the call-up, the numerical value for
the hour flashes first.
13
07.45
Use the h or g key to select the
flashing number.
14
08.55
Use the d and f keys to change the
flashing number.
15
22
Change from hour to minute and from
minute to second with the g key.
16
22
The last numerical value for the second of
the current time is alone on the main
display after switching on.
17
22
You can now either save the date and
time settings with the g key or wait
approximately 15 seconds. The control
system display will then go dark for 2–3
seconds, and the control system will
restart automatically. After the restart, the
control system is ready for normal
operation again.
The date and time are automatically
saved with the last setting after a
restart.