2
Basic
Operation
Loading Media
23
Hold the outer side of the media holder [Left] and align the left edge of the media with
the mark.
When deciding the position, hold the both sides of media holders from the outer sides and move them.
Do not hold the media directly to move.
CAUTION
Never attempt this operation while holding any location other than the
one specied.
The media may fall from the media holder, resulting in injury.
Secure the media holder by tightening the retaining screws slightly.
Decide the left and right side positions of the media nally at this step.
After this procedure is completed, if the left and right side positions do not t the proper position
when securing the media with pinch rollers, go back to this step to redo this procedure. Print qual-
ity is aected due to skew media feed, if you hold the media only to readjust the position forcibly.
Mark
To Next Page
Loading...
