MASTER STC
USER MANUAL
45
Use the Standard Navigation Mode to edit the test frequency. The meter will display
both the real time cable leakage factor (LIVE VAL) and the maximum leakage factor
detected during the same measurement session (PEAK VAL). A measurement session
does NOT get stopped when editing the test frequency, therefore the PEAK VAL
displays the maximum value of the cable leakage factor detected by the meter on all the
test frequencies set on the meter by the user while performing the same measurement
session.
Press and release the MEAS [5] key o stop the current measurement session; this will
also quit the Cable Leakage measurement.
To Next Page
Loading...