03 a 1000ML User's GuidehplA
Setting X and Manager Passcodes
Setting X and Manager Passcodes
M anager passcodes are available for added security:
• to go to the PR G and Z modes
• to go to the X mode.
A fter you program a passcode, you must use it every time you go to the
program mode or to go to X or Z report modes, depending on which you
set the passcode for.
W hen you enter a passcode, it appears as asterisks **** on the displays for
extra security.
To set manager passcodes (also known as PRG/Z passcodes)
Programming Security Set Up Manager Passcode
1 Press the press the Main menu (on) key.
2 Press the Arrow Down key to select Programming. Press the Amount
Tend Total <Enter> key.
3 Press the Arrow Down key to select Security Set U p. Press the Amount
Tend Total <Enter> key.
4 Press the Arrow Down key to select M anager Passcode. Press the
Amount Tend Total <Enter> key.
5 Follow the instructions on the display.
To set the X passcode
Programming Security Set Up X Mode Passcode
1 Press the press the Main menu (on) key.
2 Press the Arrow Down key to select Programming. Press the Amount
Tend Total <Enter> key.
3 Press the Arrow Down key to select Security Set U p. Press the Amount
Tend Total <Enter> key.
Important
The Manager passcode cannot be 0000 (zeros). The cash register will not
accept this passcode.
Caution
Write your passcodes down in a safe place. If you forget the passcodes,
you must do a Full System Clear procedure. A Full System Clear erases all
transaction information and programming. For details on the Full System
Clear, see Full System Clear on page 101.
To Next Page
Loading...
