Chapter 5 Setting Up Your Cash Register Parameters
5. % In Dept.
Specifies if -% is subtracted and +% is added to individual department
totals on the X & Z R eports. O r if these % amounts are not included in the
individual department totals and only listed at the bottom of the report in
the D iscount and A dd-O n totals.
7. Scroll Speed
Specifies the Scrolling M essage Speeds - select from Slow, M edium and
Fast. T his will set the speed for both, the instructional messages during the
Programming and R eports modes and the five customer messages on the
customer display.
8. CONS #
Specifies to reset the C onsecutive Transaction number found on each sales
receipt and on most reports after running each Z report.
9. ZCT Reset
Specifies to reset the Z-C ount number found only on Z-R eports, after
running each Z-report
10. GT Reset
Specifies to reset the G rand Total A mount on the Z-report after running
each Z-report.
11. Rounding
R ounding allows you to select how the cash register rounds-off numbers
that it generates from internal calculations, like multiplying the sales
dollar amount by the tax rate percentage, which may generate a long
string of numbers or an amount below a penny. For example $1.00
multiplied by an 8.75% tax would equal an amount of 1.0875. T his would
need to be rounded to 2-decimal places, and would be rounded-off to
$1.09 if 5/4-R ounding was selected.
6. Coupon Setting
Specifies whether the coupon discount is calculated before or after tax is
applied to an item or subtotal. T his setting will affect the department and
NET sales totals. I t is recommended that you do not change this selection
once the cash register is set up, or you might receive unexpected totals.
I f you choose after tax as your setting, your department and tax totals will
differ from the calculation shown in the report selection of this manual.
65 1000ML User's GuideahplA
To Next Page
Loading...
