Royal 1000ML - Programming Straight Add-on Tax in the United States

Chapter 7 Programming Complex Tax Rates
To select a tax system
Programming More Options Config Tax System
1 Press the Main menu (on) key.
2 Press the Arrow Down key to select Programming. Press the Amount
Tend Total <Enter> key.
3 I f you are prompted for a M anager Passcode, type the passcode number
and then press the Check key. I f you did not program a M anager
Passcode, go to the next step.
4 Press the Arrow Down key to select M ore O ptions. Press the Amount
Tend Total <Enter> key.
5 Press the Arrow Down key to select C onfig. Press the Amount Tend
Total <Enter> key.
6 Press the Arrow Down key to select Tax System. Press the Amount Tend
Total <Enter> key.
7 Select the tax system you want to use. Press the Amount Tend Total
<Enter> key.
8 Now you need to specify the values for the tax rate(s):
• Strai
ght tax values for Tax 1 and, optionally, Tax 2 through 4. See the
next section.
• Table tax values. See Programming Table Tax in the U nited States on
page 75.
• C anadian tax rates. U sing C anadian Tax R ates on page 79.
• V AT tax rates. See Using V AT Tax R ates on page 81.
Programming Straight Add-on Tax in the United States
A fter you select the tax system to use, you must specify values. T his
section explains how to specify straight add-on tax rates for the U nited
States. Straight add-on tax is the most common in the U nited States. You
must specify at least 1 tax rate and, optionally, you can specify up to 3
others.
To program straight Add-on tax rates for the United States
Programming Tax Set Up
1 Press the Main menu (on) key.
2 Press the Arrow Down key to select Programming. Press the Amount
Tend Total <Enter> key.
47 1000ML User's GuideahplA