System Options
Select from the following options to set the rounding.
A fter you are done, you can check your results. See R unning the O ptions
D ump R eport on page 82.
12. Decimal
T he decimal point is set by selecting from the following 4 options:
A fter you program the decimal point, you do not need to specify a decimal
when you ring up sales or during programming. I f you use a decimal point
when you enter a price, you hear an error beep.
T he only time you use the decimal point key is when you are ringing up
the quantity of a sale under a gallonage department. For example, 10.25
gallons of gasoline or 1.875 pounds of deli meat.
A fter you are done, you can check your results. See R unning the O ptions
D ump R eport on page 82.
To Default
R esets all the SY ST E M O ptions (System options only) to factory default
settings. I t is strongly recommended that you run a Z-report and any other
reports first (i.e. PL U , C lerk, E lectronic Journal, etc.), since resetting to
default settings may affect these reports. A fter running the Z-reports, then
return to this Parameter O ption and proceed with resetting to factory
default settings.
Table 7 Rounding
This... Rounds to this...
D own N umbers from .1 - .9 to 0
5/4 N umbers from .5 - .9 to 1 (U .S. Standard)
U p N umbers from .1 - .9 to 1
This decimal point... Looks like...
zero decimal point 0 = $ X
one decimal point 1 = $ X .X
two decimal point 2 = $ X .X X (U .S. Standard)
three decimal point 3 = $ X .X X X
a 1000ML User's GuidehplA75
To Next Page
Loading...
