MANAGER PASSWORDS
Two Manager Passwords are available as an adqed
m~sure;
ona
~~~p~d
apcesses
oD)y,tbeF-aG
-(PI!tOGRAM)
_
--
ana"Z--ri1Odesand'the secondaecesses
onlyttie'X'
mode. The Manager
PaSsword
resets every time it is used,
therefore once a password has been programmed, it must be entered every time you access the program mode
or before every
·x·
or
"r
reading is taken.
TO
PROGRAM THE "Xli
MANAGER
PASSWORD
·PRG"
+ (222222) +
(AMT
TENDjTOTAL) + (MANAGER
PASSWORD
#)
+
(NON
TAX)
4
digit"
Example: If the
"X"
password is 1212:
1.
Turn the key
to
the
·PRG" (pROGRAM) position.
2.
TYPE
(222222), then PRESS the (AMT TENDJTOTAL) Key. The letter
·P~wi"
display until Step
3
is
completed. -
3.
TYPE
(1212), then PRESS the (NON TAX)
Key.
TO
PROGRAM THE
PRG/Z
MANAGER
PASSWORD
·PRG"
+
(111111)
+
(AMT
TENDjTOTAL) + (MANAGER
PASSWORD
#)
+
(NON
TAX)
4
digit"
-
Example:
If
the PRGjZ password is
1313:
1. Turn
the
key
to
the
'PRG" (PROGRAM) position.
2.
TYPE (111111), then PRESS the (AMT TENDfTOTAL)
Key.
The letter
"P"
will
disp!ay until Step 3
is
completed.
3.
TYPE (1313), then PRESS the (NON TAX)
Key.
NOTE:
If
the Manager Password
is
programmed
as
(DOOD),
the machine will not acknowledge this password.
CAUTION: Please write
your
passwords
down
in a safe place.
If
the
passwords are forgotten, a FULL
SYSTEM CLEAR procedure will
be
necessary. - A Full System
Clear
will
erase all transaction data and_
programming. For details
on
the
Full System Clear see Page 71.
TO
USE
THE
MANAGER PASSWORDS
'PRG" or ·X·
or·r
+
(MANAGER
PASSWOR.D
#)
+ (CHECK)
4
digit"
A.
Example: Access the
0Y:
mode, the Manager Password is 1212:
1,
Tum
the key
to
the
'''X''
mode.
2.
TYPE (1212), then PRESS the (CHECK)
Key.
3.
You are now ready
to
take
an
"X·
Report
B.
Example: Access the PRG/Z modes, the Manager Password is 1313:
1.
Tum
the
key
to
the
·PRG" (PROGRAM)
or
L
mode
as
needed~
2.
TYPE (1313), then PRESS the (CHECK)
Key.
3.
You are now ready
to
program or take any reports based on your selection in Step
1.
20
To Next Page
Loading...
