"
..
.;.
GRAND
TOTAL
PRESET
"
The Grand Total
is
located at the bottom of your ·Z" Report, just above the Time and Transaction Number. The
Grand Total' is
the
only figure
that
does
notresetback-to
zeroafter
..
taking-a-7.Rep9rt,
-It iscommonly-k.nown
as
the
-running grand total". However, if you wish
you
can reset the Grand Total
to
zero
or
assign it a specific
value. The procedure used
to
assign a value
to
the Grand Total may be helpful after a Full System Clear is
performed; since
it automatically resets
the
Grand Total back
to
zero.
Extra Option: If desired, a procedure is offered
to
have the Grand Tota/reset after every
.Z'
Reading,
for
details
..
see Rag
1,
Option 1, on Page 39.
TO
SET
THE
GRAND
TOTAL
TO
ZERO
·PRG" +
(0)
+ (RETURN)
Note: It is necessary
to
take a T reading prior
to
setting the Grand Total
to
zero.
1.
Turn the
key
to
the
'T'
position.
2.
If a
PRG/Z
Manager Password has been programmed, TYPE the (PASSWORD
#),
then PRESS
the (CHECK) Key,
or
if
you
did not program a PRG/Z Manager Password,
go
to
Step
3.
3.
PRESS the (AMT TENDfTOTAL) Key,
4.
Turn the key
to
the ·PRG" (PROGRAM) position.
5.
If a
PRG/Z
Manager Password has been programmed, TYPE the (PASSWORD
#),
then PRESS
the (CHECK)
Key,
or if you did not program a PRG/Z Manager Password,
go
to
Step
3.
6.
TYPE (0), then PRESS the (RETURN) Key. The Grand Total
is
now set
to
zero. To check your
results, a
·Z·
Reading can be taken by following Steps 1 through 3 above.
TO
ASSIGN
A
VALUE
TO
THE
GRAND
TOTAL
·PRG" + (GRAND TOTAL VALUE) + (RETURN)
12
digit
# (Maximum)
Example Set the
Gral!.d
Total for $15,000.00:
1. Turn
the
key
to
the
"PRG" (PROGRAM) pOSition.
2.
If a
PRGjZ
Manager Password has been programmed, TYPE the (PASSWORD
#),
then PRESS
the (CHECK)
Key,
or if you did not program a
PRG/Z
Manager Password, go
to
Step
3.
3.
TYPE (1500000), then PRESS the (RETURN) Key. The Grand Total is now set at the value of
$15,000.00. To check your .results, a "Z· Reading can be taken by following Steps 1 through 3 in
the explanation,above "To Set The Grand Total To Zero·.
Confirmation Report: The programming
of
the Grand Total Option is done in a non-print mode. To check your
results, a Program Confirmation Report is available. For details see Page
44.
To Next Page
Loading...
