UNPACKING YOUR CASH REGISTER
and
SET~UP
PREPARATION
When your cash register is new in its factory packaging, you will find the various
ite~s
for the register packaged
separately. Look for and unwrap the following: 1 paper roll, black journal winder spindle and duplicate key sets
for
the Control Lock and Cash Drawer/Journal Lock.
,STANDARD ACCESSORIES
.
The following are included in the box with
your
cash register:
• Instruction manual.
• 1 black plastic journal winder spindle.
• 1 starter roll of standard paper tape, Royal Reorder Number 013129 (57mmj for single ply; 013130
(57mm)
for
2-ply. '
• 1 purple ribbon (already installed), Royal Reorder Number 013090. The ribbon is also available in the
color
black. Royal Reorder Number 013094. '
• 4 standard •
M"
batteries
for
battery back-up system.
• Keys:
(2)
Cash Drawer/Journal
Lock
keys
'(515).
(2)
Program keys
(PRG.
58-090004).
(2)
Register keys
(REG.
58-090001).
INITIAL
SET
UP
IT
IS IMPORTANT THAT YOU READ THE INITIAL SET-UP AND
MAiNlENANCE
INSTRUCTIONS BEFORE
ATTEMPTING TO
OPERAlE
THE CASH REGISTER.
1.
Locate on level surface - Before operating,the cash register, be sure it is placed on a level
surface
to
permit smooth operation of the register cash drawer .
.
2.
IMPORTANT: THE
C~SH
REGISTER MUST BE PLUGGED IN BEFORE INSTALLING THE
BACK-UP BATTERIES. This cash register operates on any standard three-hole electrical outlet
(115-120 volt, 60 hertz). It is recommended that the
Cash
register be connected
to
an electrical
circuit where no other electrical device
or
appliance is connected which may overfoad the circuit
or
cause electrical interference with the cash register. It is best that a single circuit be provided
'for
register operations.
3.
Be sure the cash register is plugged in and install the 4 standard
OM"
batteries provided. Refer
to
Page 9 for battery installation instructions.
4.
Install paper - Refer
to
Page 10 for paper installation instructions.
MAINTENANCE
OF YOUR REGISTER
Your register must remain uncovered when turned on; this will allow proper
COOling
of electronic
components.
Use a dust cover when the register is
not
in operation
to
protect mechanical components from
dust
Take care
to
keel'
beverages and other liquids away from the machine
to
avoid spills which may
damage electronic components (use optional protective keytop cover
to
prevent damage
to
machine).
To clean. use a soft dry cloth. Do not use harsh solutions containing alcohol.
Your machine should be kept in areas free from dust. dampness or extreme temperatures (hot
or
cold).
After storage in extreme temperatures (below 32 degrees fahrenheit or above 104 degrees
fahrenheit). allow the temperature inside the machine enough time
to
reach room temperature
before switching on.
Never pull the paper tape through the printhead. To prevent damage, always use the electronic
paper feed keys.
Should electronic service be needed. a
Royal
authorized service center is recommended.
To Next Page
Loading...
