2. Description of the Barracuda
Maintenance
2012-10/4.3A
47
Barracuda & QABrowser Reference Manual
8.
Note that storing the new firmware in the flash memory may take several minutes for
each module. The RTI Updater will indicate which modules have been updated.
9.
Power off the Barracuda and disconnect the serial cable when the program indicates
that everything is OK.
If you have any problem with your Barracuda after updating, re-install the firmware
again before contacting your local distributor or RTI Electronics. To re-install firmware
repeat step 1 to 9 above, but before performing step #6 go to the menu Settings and
select Always Overwrite.
If you want to see more details of what is updated, use the menu
Settings - Advanced, and you will see more information as shown in the
figure below.
To Next Page
Loading...
Need help?
General