Read the unpacking instructions carefully before unpacking the instrument.
This instrument weighs approx. 130 kg. The instrument can be moved with ease on casters, but two or
more persons should work together when removing the instrument from the pallet on a slope. When
removing the instrument from the pallet this way, indicate so in the shipping document and inspect the
cargo for damage. As a rule, the instrument is unpacked/installed by Sakura Finetek or our authorized
dealer.
Avoid connecting the instrument to a transformer not manufactured by Sakura Finetek.
When moving the instrument to a region where different voltage is used, contact the Sakura Finetek
Technical Support representative or local representative.
Those who have experience operating a Sakura Finetek product or products other than
this instrument must also read this manual. Also, those who will be operating this
instrument should receive training first.
Sakura Finetek will assume no responsibility for any accident that may result from operating the instrument
without reading this manual first.
Safety mechanisms installed in this instrument only represent the minimum measures
taken to prevent accidents. The responsibility for safe operation of the instrument lies
primarily with the owner of the instrument, and persons in charge who operate the
instrument.
Do not install the instrument in a place used as a living area.
If a common area is used, an exhaust system is required. Provide electrostatic discharge protection in the
installation location.
Install the instrument indoors. Do not place the instrument in a location exposed to
direct sunlight, snow or rain.
This product is specified for indoor use, so do not use it outdoors. Ultraviolet rays and high temperature
may damage the instrument. Never use the instrument while exposing it to snow or rain because it may
cause electric shock or short-circuit.
Do not use the instrument, if damaged, even when operating it is possible.
Injury or electric shock may result.
Should the instrument malfunction, turn off the power and disconnect the power plug
from the power outlet. If processing is still in progress, immediately protect the tissues.
Should malfunction occur, turn off the power and contact the Sakura Finetek Technical Support
representative or local representative. Disconnecting the power plug also cuts off the main power supply.
When installing the instrument, select a place where the power outlet is not concealed and the power plug
can be disconnected any time in case of emergency.
Do not disassemble or modify the instrument.
The instrument may malfunction or cause accident, thus creating a dangerous situation.
To Next Page
Loading...
Need help?
General
