Cubis MSA User Manual 129
User Management
Step 6: Define password protection
If you assign a password, this profile cannot be used until the password has been
entered.
t Select the corresponding option to define whether the user profile
is password-protected or not.
The password will be defined in the step after next.
Only the Administrator can open the user profile without the password
(for example, if the user forgets the password) and assign a different password.
The Administrator can remove the password protection so that a new password
can be set, if desired.
If the administrator forgets the password: Please contact your Sartorius Service
Center
Step 7: Check all settings
t Use the scroll bar or press the down arrow to view all settings.
t To modify a setting, press the corresponding button. This opens a screen
showing the options for that setting.
t If the settings are correct, press 0GZV.
Step 8: Define the password (If password protection enabled)
y If you selected the option for password protection in Step 7 (see above),
you are now prompted to enter the desired password twice.
t Press the upper button.
t Enter the desired password (minimum 4 characters, maximum 8;
only numbers and uppercase letters are permitted).
t Press the lower button, and enter the password again.
t Touch 0GZV.
Step 9: Enter user names and descriptions
t To enter a name for the user profile, touch the
7UGTPCOG button.
The user name is shown on the top right of the display during operation as
long as the respective user profile is active.
t Enter the name (max. 40 characters) and touch 1-.
t To enter a description of the user profile, touch the 7UGT&GUETKRVKQP button.
The user description can be viewed at any time during operation of the balance
by pressing the user info area in the display (see “User Interface (Touch Screen)”).
t Enter the description and touch 1-.
t To complete the process, touch 5CXG.
To Next Page
Loading...