4 Cubis MSA User Manual
Safety Precautions
Safety Precautions
This device complies with European Council Directives as well as international regulations and standards for electrical
equipment, electromagnetic compatibility, and the stipulated safety requirements. Improper use or handling can,
however, result in damage and/or injury.
This device should only be operated by trained personnel.
Operators must read these installation instructions, particularly the safety information, and must be familiar with
the operation of the equipment. The operator is required to supplement these safety precautions as appropriate. The
operating personnel must be provided with the appropriate training.
The requirements pertaining to applicable installation regulations must be followed when using electrical equipment
in systems and environmental conditions with increased safety requirements. Relevant laws, standards, regulations,
guidelines and environmental protection laws valid in your country must be observed.
Always keep the equipment and balance freely accessible. Any installation work or balance operation that does not
conform to the instructions will result in forfeiture of all claims under the manufacturer’s warranty.
Danger of Explosion!
1
Do not use this equipment in hazardous areas in which explosive materials are present.
Danger of Electrical Shock!
If the device is not used in accordance with the instructions, this can affect the product liability for the device.
2
Make sure that the voltage rating printed on the AC adapter is identical to your local line voltage. The wall outlet
must have a protective grounding conductor. The operating instructions included with the AC adapter must be
followed.
2
Do not switch on the equipment if the AC adapter or power cord are damaged.
If the balance itself, the AC adapter or any cables on the balance are damaged, disconnect the equipment from the
power supply and secure it so that it cannot be turned on.
2
Chemicals (e.g. gases or liquids) that can corrode and damage the inside or outside of the balance, AC adapter, power
cable or peripherals must be kept away from the equipment.
2
Do not operate the balance unless the housing and the display are undamaged and the housing is closed so that
inadvertent contact with parts inside the equipment is not possible. Make sure that no liquids penetrate the balance
and do not allow conductive parts to touch the balance.
2
Note on Installation:
The operator shall be solely responsible for any modifications to the equipment and for connecting any cables or
equipment not supplied by Sartorius.
Information on operational quality is available upon request from Sartorius.
You should only use peripherals and options supplied by Sartorius.
To Next Page
Loading...
Need help?
General