Cubis MSA User Manual 107
Totalizing
Totalizing
Purpose: Adding up weight values and calculating values. The weight values of all individual
components are recorded and can be logged. The weight values and the component
counter are saved in protected memory so that an interrupted totalizing process
can be continued after the balance has been turned off or after a power failure.
Options: You can save a maximum of 65535 components.
User rights: All settings for the “Totalizing” application are saved under the active user profile.
Each user can make their own settings for this application. For this reason, make
sure that the desired user profile is selected before you start.
Results: When a user creates a local totalizing task, the results are only saved
locally for that user. The results of global tasks, however,
are available to all users and the administrator.
Combination options: Calculation, averaging, weighing in percent, parts counting, checkweighing,
mass unit conversion, second tare memory, individual identifiers, (SQmin function,
DKD measurement uncertainty)
Configure Task: Totalizing
D
(* = factory setting)
t Define how the weight value will be applied.
/CPWCNN[ The weight value is applied as soon as the corresponding button is
touched.
#WVQOCVKECNN[HKTUVXCNWGCVUVCDKNKV[The weight value is applied auto-
matically as soon as the balance has stabilized after filling and the value exceeds
the minimum load.
#WVQOCVKECNN[NCUVXCNWGCVUVCDKNKV[The last weight value with stability is
applied automatically, as soon as the balance is unloaded and the value falls short
of the minimum load. If stability was reached repeatedly between
measurements, the last stable weight value will be stored.
You must now select the minimum load to be applied:
PQPGFKIKVU
Weighing Mode with Automatic Storage:
t Select the weighing mode to be used for storing the weight values.
+PKVKCNYGKIJKPI: Initial weighing of samples in a container.
(KPCNTGCFQWV: Final weighing of samples in a container.
To Next Page
Loading...
Need help?
General