Sartorius MSA3.6P - Pin Assignment Chart for Connecting Peripherals; Control Inputs;Outputs

Cubis MSA User Manual 137
Interfaces
Pin Assignment Chart for Connecting Peripherals
Purpose: For Sartorius peripheral devices
Female Interface Connector: 25-pin D-Submini (DB25S) with screwed fastening
Required Male Connector (Recommended): 25-pin D-Submini, DB25S, with integrated shielded cable clamp and shield plate
assembly (Amp type 826 985-1C) and fastening screws (Amp type 164 868-1)
1
14
13
25
Pin assignment 25-pin socket, RS 232:
Pin 1: Signal ground Pin 14: Internal ground (GND)
Pin 2: Data output (TxD) Pin 15: Control input/output 1
2
)
Pin 3: Data input (RxD) Pin 16: Control input/output 2
2
)
Pin 4: Signal GND Pin 17: Control input/output 3
2
)
Pin 5: Clear to Send (CTS) Pin 18: Control input/output 4
2
)
Pin 6: Not used Pin 19: Control input/output 5
2
)
Pin 7: Internal ground (GND) Pin 20: Data Terminal Ready (DTR)
Pin 8: Internal ground (GND) Pin 21: Not used
Pin 9: Not used Pin 22: Not used
Pin 10: Not used Pin 23: Not used
Pin 11: + 12 V output Pin 24: Not used
Pin 12: Reset _ Out
1
) Pin 25: +5 V output
Pin 13: + 5 V output
1
) = Peripherals restart
2
) = Allocation of control input/outputs menu-configurable (see below)
Control Inputs/Outputs
Data Output /
Setting
Pin 15 Pin 16 Pin 17 Pin 18 Pin 19
Infrared sensor
YHS01MS
Input 1:
*”PRINT” key
Output 2:
** “Smaller”
Output 3:
** “Equal”
Output 4:
** “Larger”
Output 5:
**”Setp”
Hand switch
YHS02
Input 1:
*”PRINT” key
Output 2:
** “Smaller”
Output 3:
** “Equal”
Output 4:
** “Larger”
Output 5:
**”Setp”
Foot switch
YFS01
Input 1:
*”PRINT” key
Output 2:
** “Smaller”
Output 3:
** “Equal”
Output 4:
** “Larger”
Output 5:
**”Setp”
Triple Foot switch
YPE01RC
Input 1:
Left
*”PRINT” key
Input 2:
Right
*Left Shieldpl.key
No function
(disabled)
No function
(disabled)
Input 5:
Center
*”TARE” key
Control display
YRD11Z
Output 1:
Currently
no function
Output 2:
** “Smaller”
Output 3:
** “Equal”
Output 4:
** “Larger”
Output 5:
**”Setp”
Control inputs
Input 1:
*”PRINT” key
Input 2:
*Left Shieldpl.key
Input 3:
*no function
Input 4:
*no function
Input 5:
*”TARE” key
Control outputs
Output 1:
Currently
no function
Output 2:
** “Smaller”
Output 3:
** “Equal”
Output 4:
** “Larger”
Output 5:
**”Setp”
* Default allocation of input, otherwise configurable
** Allocation of outputs, on checkweigher