Sartorius MSA3.6P - Configuration Options for the Printer Output Operating Mode

140 Cubis MSA User Manual
Interfaces
Configuration Options for the Printer Output Operating Mode
You can modify all settings for this operating mode depending on the configured
printer type.
– Printer type: ;&2%'/;&2%'/;&2%'/7PKXGTUCN/
;&2+5%'78
– Selected protocol: Hardware handshake
– Baud rate: 300 to 19200 baud (*9600)
– Data bits: 7 or *8
– Parity: 0QPG/*1FF (odd)/QFF (even)
– Stop bits: *1 or 2 stop bits
– Log data: *6WTPQHH/6WTPQP
The following setting options are available for the Printer types:
– ;&2%': No setting option, all parameters are permanently defined
– ;&2%': All can be configured except stop bits
– ;&2%': All can be configured except data bits and stop bits
– 7PKXGTUCN: All can be configured
– ;&2+5%'78: No setting option, all parameters are permanently defined
– ;&2$6%' (only for optional Bluetooth module, Com C): No setting
option, all parameters are permanently defined
Configuration Options for the SICS Operating Mode
You can change all settings for this operating mode.
– Selected protocol: 0QRTQVQEQN/*5QHVYCTGJCPFUJCMG
:10:1((
/**CTFYCTGJCPFUJCMG465%65
– Baud rate:  to $CWF, *9600
– Data bits:  or *
– Parity: 0QPG/*1FF/'XGP
– Stop bits: * or  stop bits
– Log data: *6WTPQHH/6WTPQP