Sartorius MSA3.6P - Configuring Network Operation (Ethernet)

146 Cubis MSA User Manual
Interfaces
Configuring Network Operation (Ethernet)
Preparation: Before you can start with the configuration, you will require some information
about your network. Please contact your network administrator. The important
question is whether your network supports DHCP or not.
DHCP With DHCP, you can automatically link a (new) balance to an existing network
without having to configure it manually. Normally, the balance (client) only
requires the automatic acquisition setting for IP address (factory setting).
DHCP is supported In this case, no additional information is required.
DHCP is not supported In this case, you need the following information from the network administrator:
– IP address
– Subnet mask
– Default gateway address
Device name (host name): This name can be changed if required.
This name is used to select the balance in the network.
wSelect Network Settings (Fixed Setting)
t If appropriate, toggle to the System Settings menu.
t Select the &GXKEGKPHQTOCVKQP submenu and slide the right scroll bar down.
t Select %QPHKIWTGRQTVU.
t Open the 0GVYQTMRCTCOGVGTU'VJGTPGVsubmenu.
t To change the IP settings, touch the input field behind
0GVYQTMEQPHKIWTCVKQPinput field.
t Select 7UGHKZGF+2CFFTGUU and confirm with 1-.
t In the overview, check all settings and change as required.
&GXKEGPCOG (host name): You can select this name freely.
This name is used to select the balance in the network.
t If you then want to produce an Ethernet connection, write down the IP address
now.
t To save the network configuration, touch 5CXG.
y The Configure ports submenu is displayed.