4 Operation and Configuration
117
S84-ex/S86-ex Operator Manual
RIBBON NEAR END
Enable or disable the detection of the ribbon near end.
• ENABLE: Detect and notify when the ribbon is about to run out.
• DISABLE: Do not detect the ribbon near end.
Note
Shows for the thermal transfer model only.
LABEL RE-DETECT
Set whether or not to re-detect the label pitch when the power is on after
the head opens/closes.
• ENABLE: Re-detect the label pitch.
• DISABLE: Do not re-detect the label pitch.
SET PASSWORD
Enable or disable password input to various modes.
• ON: Password input is required to enter various modes.
• OFF: Password input is not required to enter various modes.
You can enable password input for the following modes:
USER MODE, INTERFACE MODE, MEMORY MODE,
ADVANCED MODE, HEX DUMP MODE and SERVICE MODE
PASSWORD NO.
Set the four digit password for entering various modes.
Move the cursor using the
/ buttons, change the value using the
/ buttons and then press the ENTER button to confirm the pass-
word.
To Next Page
Loading...
