Scanivalve MPS4232 - File Contents; List

41
MPS4232
Section 5: Software
EXAMPLE LOAD scan.cfg
>

COMMAND TYPE
TYPE Get
DESCRIPTION Commands the MPS to list all sengs, or a specied group of sengs, that are stored on the
ash.
SYNTAX TYPE <lename>
Where <lename> is the name of the le, including the extension. The le must be a congura-
on le.
RETURNS The le contents and a prompt when ready to accept a new command.
EXAMPLE TYPE ip.cfg
SET IPADD 192.168.0.240
SET SUBNET 255.0.0.0
SET MAC 0.96.93.95.0.1
SET GW 0.0.0.0
>

COMMAND LIST
TYPE Funcon
DESCRIPTION Commands the MPS to list all sengs, or a specied group of sengs, that are stored in RAM.
SYNTAX LIST <group>
Where:
<group> Filename Contents
IP ip.cfg IP (bootloader) Variables
ID id.cfg Idencaon Variables
S scan.cfg Scan Variables
PTP ptp.cfg PTP Variables
FC Fc.cfg Field Cal Conversion Points
C Cal_<sn>.cfg Full Calibraon Coecients
M misc.cfg Miscellaneous Variables
FTP p.cfg FTP Variables
O oven.cfg Oven Control Variables
PGA Cal_<sn>.cfg Programmable Gain Sengs
T Cal_<sn>.cfg Conversion Sengs
RETURNS <seng> <variable>
::: ::: ::: :::
<seng> <variable>
Followed by a prompt when ready to accept a new command.