Scanivalve MPS4232 - IP Variables; List IP Settings (LIST IP); Set IP Address of the MPS (IPADD); Set Subnet of the MPS (SUBNET)

46
MPS4232
Section 5: Software

The IP sengs control the IP address and associated network idencaon sengs of the MPS4200. The IP conguraon is
accessed by the command LIST IP. These sengs can only be saved using the SAVE IP command.

TYPE Get
DESCRIPTION Returns all of the IP sengs.
SYNTAX LIST IP
RETURNS All of the IP seng followed by the prompt.
EXAMPLE LIST IP
SET IPADD 10.0.1.222
SET SUBNET 255.255.0.0
SET MAC 0.96.93.90.0.100
SET GW 0.0.0.0
>

COMMAND IPADD
TYPE Set/Get
DESCRIPTION Sets or retrieves the IP address of the MPS.
SYNTAX IPADD <ipadd>
Where <ipadd> is any valid IP address in the form nnn.nnn.nnn.nnn
RETURNS Prompt when ready to accept a new command
EXAMPLE SET IPADD 10.0.1.222
>
DEFAULT 191.30.95.100
RANGE Any valid IP address

COMMAND SUBNET
TYPE Set/Get
DESCRIPTION Sets the subnet mask.
SYNTAX SET SUBNET <mask>
Where <mask> is in the form nnn.nnn.nnn.nnn
RETURNS Prompt when ready to accept a new command
EXAMPLE SET SUBNET 255.255.0.0
>
DEFAULT 255.255.255.0
RANGE Any valid subnet mask

COMMAND MAC
TYPE Set/Get
DESCRIPTION Sets the hardware’s MAC address.