Scanivalve MPS4232 - Set Gateway (GW)

47
MPS4232
Section 5: Software
SYNTAX SET MAC <xxx.xxx.xxx.xxx.xxx.xxx>
Where <xxx.xxx.xxx.xxx.xxx.xxx> is any valid MAC address in decimal format.
RETURNS Prompt when ready to accept a new command
EXAMPLE SET MAC 0.96.93.90.0.123
>
DEFAULT 000.096.093.xxx.yyy.yyy
Where xxx is the family code
where yyy.yyy is the serial number of the module.
NOTES This value is set by Scanivalve at the factory and should not be altered unless otherwise advised.

COMMAND GW
TYPE Set/Get
DESCRIPTION This is the IP address of the network gateway used for network communicaon. If not present
0.0.0.0 must be used.
SYNTAX SET GW <gw address>
Where <gw address> is any valid IP address in the form nnn.nnn.nnn.nnn
RETURNS Prompt when ready to accept a new command
EXAMPLE SET GW 10.0.2.123
>
DEFAULT 0.0.0.0