Scanivalve MPS4232 - Set the Oven Stop Command (STOPOVEN); Set the Temperature Command (TEMPOVEN)

67
MPS4232
Section 5: Software

COMMAND STOPOVEN
TYPE Set/Get
DESCRIPTION Sets the command to stop the oven / thermal chamber.
SYNTAX SET STOPOVEN [<stop oven command>]
If no command is entered, a CR is sent to the oven.
RETURNS Prompt when ready to accept a new command.
EXAMPLE SET STOPOVEN STOP
>
DEFAULT 0
RANGE These values are not range checked.

COMMAND TEMPOVEN
TYPE Set/Get
DESCRIPTION Sets the command to send the oven / thermal chamber to a temperature.
SYNTAX SET TEMPOVEN [<set temperature command>]
If no command is entered, a CR is sent to the oven.
RETURNS Prompt when ready to accept a new command.
EXAMPLE SET TEMPOVEN SETP1,
>
DEFAULT 0
RANGE These values are not range checked.