47 Mega-800 SCINCO
page. The default absorbance value will be used (displayed on the screen).
Fig. 5.14 Set the standards concentration value and absorbance value
③ Measure the standards absorbance
Standards absorbance measurement is used when the user knows the standards
concentration but does not know the standards absorbance. First select the No.2 to use
cell 1 measure absorbance, as shown in the following figure.
Fig. 5.15 Measure the standards absorbance
Note:
The system accepts integral as the Std. No.
，
the range of which is 1 to Std. Number. If the
input value exceeds 7 digits (including decimal point and negative sign) or exceeds the range,
the system will delete what has been entered automatically and you should start a new entry
again.
The system accepts integral and decimal as the concentration and sbsorbance, the range
of which is –999-999. If the input value exceeds 7 digits (including decimal point and negative
sign) or exceeds the range, the system will delete what has been entered automatically and you
should start a new entry again.
To Next Page
Loading...