• CMTS downlink
• Analog carrier
These predefined thresholds may be used when defining a monitoring configuration, but it is a good idea
to create editable copies of these threshold templates and use these copies rather than the originals.
Doing so will allow fine-tuning of parameters later on.
There are two different ways of creating user-defined thresholds. To create a new threshold template
from scratch the operator should click the
Add new threshold
button. A pop-up window will appear
allowing the user to define alarm conditions and set the round-robin cycling time. The default values of
the different parameters settings are in accordance with the ETSI TR 101 290 specification. Another way
of creating a user-defined threshold template is by highlighting one of the threshold templates already
defined and then click the
Duplicate highlighted
button. The copy created this way may be edited
during the fine-tuning phase of system configuration.
Deleting an ETR threshold template is done by highlighting the threshold template that should be
removed and clicking
Delete highlighted
. Note that if the deleted threshold template is assigned to a
stream currently being monitored, the new threshold for that stream will default to the predefined
Default
threshold template.
It is possible to perform multi-editing of existing threshold templates by selecting several threshold tem-
plates (using the regular Ctrl + click or Shift + click functionality) and clicking
Edit selected
. Parameters
that differ between the threshold templates will be represented by an asterisk in the
Edit ETR threshold
view. Changes made will affect all selected threshold templates.
152 VB2xx GigE User’s Manual version 5.4
To Next Page
Loading...
Need help?
General
