E.3 Delete any existing probe stream recordings
If any stream recordings is stored on the probe, this may prevent software upgrade, as there might not be
enough internal disk space available for the software image upload to be possible. Therefore delete any
recordings prior to software upload – this is done in the RDP — Control view.
E.4 Transfer the image to the probe and save to flash
Using the software upload functionality in the Data view
From the
Data — Software
view select the software image file to be uploaded and click the
Go!
button.
When the software has been successfully transferred to the probe click the
Save flash
button and
confirm.
Progress bars are displayed to show the flash save status.
264 VB2xx GigE User’s Manual version 5.4
To Next Page
Loading...