Timezone: The time zone as selected by the operator in the Setup — Params view.
Time: The current local time (configured in the Setup — Params or Setup — Time view).
RDP
(Bulb):
The RDP bulb indicates whether RDP is active or not. Green indicates RDP active whereas
grey indicates that RDP is currently not active.
Active:
The RDP active state is either yes or no, yes indicating that RDP relaying or alarm triggered
recording mode has been selected by the operator in the RDP view.
Counters and alarms
Clear all:
Click the
Clear all
button to reset all counters, graphs and alarms. All VB220
measurement and alarm history is cleared. Note that it is not possible to undo
this operation.
Last cleared:
The time the
Clear all counters
button was last clicked. If no time is indicated the
counters have not been cleared since VB220 startup/reboot time.
Probe
Name: The VB220 name as defined by the operator in the Setup — Params view.
Location: The VB220 location as defined by the operator in the Setup — Params view.
Access:
The access rights of the current user. Access rights are either full access or read only
access, and are defined by the operator in the Setup — Login view.
Resources
CPU level:
The CPU level indicates the workload of the probe, on a scale from 1 to 10 of total
capacity.
Free mem: The available free memory.
Free disk: The available free probe disk space.
The probe employs a memory-based disk, which means that the amount of available free memory
decreases as more files (such as recordings, thumbnails, PCAPs, etc.) are stored.
Traffic
RX data: The total bitrate of received data traffic
Monitored data: The total bitrate of multicasts and unicasts monitored (analyzed) by the probe
Data interface
VB2xx GigE User’s Manual version 5.4 47
To Next Page
Loading...
Need help?
General
